If you installed CoolSpace
just like we told you, then you don't have to do anything more. You don't have to touch a
single button or learn how to program a controller. Jut plug it in and walk away!
CoolSpace is a true "plug-and-play" machine. Factory-set Auto mode will reach
and hold a storage temperature of 57F (14 C), constant within one degree. Relative
humidity will normally remain within a range of 40% to 80%. And while CoolSpace delivers
maximum power and humidity, it will also achieve maximum efficiency. In Auto mode,
CoolSpace will control its circulation speed and compressor cycling according to its own
intelligent analysis of ambient conditions and cooling load. This, in turn, will ensure
long life for the motor and compressor.
Hey, this thing is really in control!
CoolSpace is equipped with an Alternate operating mode, which you can select by
pressing and holding the "Set" button for 4 seconds. "F C" will appear
in the display indicating "Fan Control" mode, which means CoolSpace will
self-adjust its fan speed to attain quietest possible operation. The Alternate mode symbol
will display every 4 seconds, and the enclosure temperature will display alternately. As
in Auto-Mode, storage temperature can be changed in Alternate mode by pressing the
"set" button for a moment, then pressing the "UP" or "DOWN"
symbols. If you like, you can thin of Fan Control and Default modes as "Winter"
and "Summer" settings. In a typical winter situation where household temperature
is constant 75F and relative humidity stays low, Fan Control may be the best choice. If in
summer conditions, however, ambient temperatures in the house frequently rises above 75F
and humidity tends to become extreme, then Default-mode will function best. For best
overall performance and humidity control, we recommend you operate your unit in Auto mode.
(Note that the unit will automatically reset to Auto-mode if it determines that Fan
Control is not adequate to the cooling load.) To deselect the Alternate mode, simply
unplug the power, then replug after ten minutes; CoolSpace will return to Auto-mode and
set-temperature to 57F.
What you see is what you get...
At initial power-up, CoolSpace will display the symbol "--" for about 5
seconds. Then it will display the temperature inside the enclosure. After 5 minutes, the
fans and compressor will begin operation. (This 5-minute delay is a safeguard against
compressor damage.) You can verify the pre-set storage temperature by pressing "SET:
button for a moment, until the storage temperature appears on the display. To change the
storage temperature, press the "SET" button for a moment, then press the
"UP" and "DOWN" symbols (press once for each degree of change).
Don't be alarmed...
CoolSpace has its own electronic alarm and safeguard system. The alarm will display
with a flashing "A L" in the window if the enclosure temperature rises about 72
F and the unit will further protect itself by shutting off its fans and compressor. During
the first 12 hours of operation, the alarm will ignore this condition as CoolSpace
gradually achieves storage temperature. To reset the alarm and return to default settings,
simply unplug the unit for about 10 minutes, then plug it in again. Not that if a power
interruption occurs during a compressor cycle, the unit will remain off for 5 minutes
before re-starting, as a further safeguard against compressor damage.
How'd they do that?
It's all in the wrist -- literally, in YOUR wrist, when you plug in your CoolSpace. A
high-resolution fully digital sensor instantly brings to life the electronic genius of
CoolSpace. The sensor tell CoolSpace, very precisely, what's going on "out
there" and "in here". Then CoolSpace can make intelligent decisions about
motor speed and fan speed, compressor cycling, energy conservation, and so on. Hey, this
machine isn't just smart - it KNOWS it's smart!
